Siheyuan: Starting from a fitter

Chapter 338 193nm ArF Excimer Laser
Representative Luo played for a while, his face flushed with excitement.Then he ran to Li Guocheng's desk, picked up the phone and was about to dial, but Li Guocheng held him down.

"Go back and use the intercom!"

"Oh, I'm so anxious." After saying that, he hurried to Building 3.

Looking at the embarrassed back, Li Guocheng couldn't help but smile.

After get off work, Representative Luo stayed in Li Guocheng's office, holding operating instructions, improvement instructions and programming manuals in his hands and looking at them carefully.

"Lao Li, this is the most detailed manual I have ever seen. It is clearly organized and easy to find."

Representative Luo was amazed as he watched.

After making sure that the entire Building 1 was cleared, the two soldiers took a large piece of canvas with two small holes in it.

They covered the robot's body with canvas, leaving only two eyes exposed, and left the building in an elevator controlled by a tablet.There was a box truck waiting at the door of the building.

"Lao Luo, what should we do tomorrow?" Li Guocheng shouted at Representative Luo's back.

"Let it go first." Representative Luo didn't even look back, all his attention was focused on the robot.

In this case, Li Guocheng didn't bother to pay attention and just relaxed.

The next day, when Li Guocheng came to the laboratory, he ordered Xiaoxiaoerer to move freely as long as he did not leave the comprehensive laboratory.

Now that the robot has been revealed, Xiaoyi and Xiaoer can blatantly act as his assistants.

As long as others are not allowed to actually touch it, they will not think it is artificial intelligence, but only ordinary robots.

The first task Li Guocheng gave them was to design a humanoid robot.

Li Guocheng stored some publicly available robot control algorithms on a USB flash drive and left the office.

Find Professor Liu Shengjun on the 2nd floor.

After chatting with their group for a while, I found out that they are working on upright robots.However, the control algorithm is still in the path planning algorithm stage.

That is, black tape is put on the ground to form a path.The robot determines the direction of movement based on the image "eyes see".

Moreover, the motion actuator is a wheel, and two servo motors control a set of wheels respectively.

It is also stumbling when moving, and I will fall if I look at it a few times.

Vision is also based on the camera, comparing black and white to determine the route forward.

It can only be said that they are still in their infancy.

What Li Guo traded to them was the seven primary algorithms of obstacle avoidance, positioning, map construction, movement control, target inspection, tracking and navigation.

It’s just that artificial intelligence and deep learning algorithms are missing.

Although it is not the final algorithm, for them now, this is enough for them to digest for a while.

Professor Liu is a good judge of things. Like the previous two professors, he was immersed in it and didn't care about Li Guocheng standing next to him.

He had no choice but to call a student who looked familiar.

"Students, please remember to tell your teacher later that you can study these things, but you cannot leak them."

"Okay, Director Li." The student was obviously very nervous.

Li Guocheng asked him to repeat the instruction just now, and returned to the office after making sure that it was correct.

The next few days are the most relaxing stage for Li Guocheng. Except for a 9-axis 5-linkage that requires him to process a large flat plate, other projects are in charge of others.

After several years of investment, the laboratory's scientific research capabilities and treatment have been recognized by teachers and students of the joint R&D institution, and more than 100 students have been retained in the laboratory.

Most of them have joined the team of Zhang Zhijing, Yan Jiefang, Zhou Xiaojuan, and Master Yi, and only a small number are still participating in school projects.

The graduate school has been specially approved to be established. All college and undergraduate students in the laboratory can apply to apply for postgraduate studies in Longhua Science and Technology Laboratory. If they pass the graduation examination, they will be awarded a nationally recognized postgraduate degree.

It’s just that the Automation College for undergraduates that I have always wanted to establish has not received approval.

However, you can participate in correspondence studies at Hangzhou University of Science and Technology and Kyoto Institute of Technology. After passing the examination, you will be awarded a nationally recognized undergraduate degree.

In this way, Longhua Technology can solve the academic problem for the high school students who were recruited urgently.

In another year, a group of students from the correspondence university will graduate. If they get their academic qualifications, it will be easy to apply for Longhua Graduate School.

Because of the good cooperation between Hangda University and Kyoto Institute of Technology, first-year graduate students can participate in basic subject studies offered by the two schools on weekends.

Such as advanced mathematics, university physics, signals and systems, computer theory, etc.

One year later, I studied professional courses in the laboratory, and the class time was also on weekends.

In the form of sponsorship, we have received strong support from two universities, and teachers are assigned to teach on time.

In this era, if there is an opportunity to go to school, that kind of enthusiasm will not be seen in future generations.

Therefore, many employees in the laboratory now work during the day, study in the dormitory at night, and have appointments to attend classes on weekends.

Such a collective learning atmosphere gradually formed the corporate culture of Longhua Laboratory's learning organization, which influenced batch after batch of employees.

On this day, Li Guocheng was hiding in his office reading. Without knocking on the door, Professor Yuan rushed in. If he hadn't been prompted by the mistress, he would have been shocked.

Li Guocheng stood up and asked Professor Yuan to sit on the sofa, "What's the matter, Professor Yuan?"

"Good news, great news, hahaha." Professor Yuan, who was usually elegant and calm, was now acting very wildly.

Li Guocheng suddenly realized something, "Professor Yuan, you have done it."

Professor Yuan nodded heavily, "Under your guidance, we have finally developed a 193nm ArF excimer laser."

Li Guocheng suddenly jumped up, which shocked Professor Yuan.

"Okay, great." Li Guocheng turned around unconsciously in the office, his eyes a little moist.

"After years of persistence, we finally see the light. With DUV, can EUV be far behind?"

Next, as long as we break through the reflective lens, realizing 100 nanometer technology will not be a dream.With the enrichment of experience, the 50nm and 28nm processes will be broken through one after another.

Coincidentally, Zhou Xiaojuan's team made a breakthrough in the trial production of latex light-shielding film three months ago, and Li Guocheng directly chose quartz glass as the substrate.

It has high chemical stability and thermal expansion rate, and has lower requirements on the process and production environment than other materials in terms of use environment.

Now only the reflective lenses are left. Once developed successfully, a modern DUV lithography machine can be successfully trial-produced.

With the current strength of the laboratory, successful research and development is only a matter of time.

Li Guocheng called Zhou Xiaojuan, Zhang Zhijing, Yan Jiefang and Master Yi to the conference room.

It is determined that the main work direction of the laboratory will turn to the research and development of DUV lithography machines.

"Xiao Li, what about the processing of the parts of the 9-axis machine tool?"

Li Guocheng was also stunned, "Ah! In that case, Master Yi, you first lead the team to complete the task at hand, and then join after it is completed."

"Well, I'll try to keep an eye on it."

Although Master Yi is missing, he can first hand over the task to Xiao Yi and Xiao Er.

So during the entire task setting meeting, he was very excited and wanted everyone to start work immediately.

His performance aroused great confusion among the participants.

thanks for your support! ! !Please recommend!Asking for a monthly ticket!Please comment!
(End of this chapter)